5.Push INT button (interval) to cycle through the choices for how often to log a data point. Stop when the desired interval is displayed. Notice how much time can be covered with the remaining free memory.
6.Push and hold the START button until the screen goes blank (two seconds) to begin a new data logging session. The unit will now display the gas concentration. The Lg symbol in the left side of the display indicates that the unit is logging data. If you watch this symbol carefully, you will see it change to an “s” each time a data point is stored.
To Stop the Data Logging Session
7.Push the MENU button.
8.Push the LOG button.
9.Push and hold the STOP button until the screen changes to CLEAR / INT
/START / MODE (two seconds).
10.Push the DONE button to get back into normal operation mode.
Working with the “EC-P2” program:
The
Turn on the Honeywell
The program contains two tabs, one marked “Download” and one marked “Configure”. Review the settings on the “Configure” tab, making changes as necessary.
From the “Download” tab, review the Link Status block in the lower right hand corner. It should indicate “Link OK”. Link Trouble can be caused by selection of the wrong Com port in the Configure Tab, improperly connecting the
turning on the Honeywell
When you are ready to transfer data from the Honeywell
These files can now be opened with Excel (use .csv filename), Lotus 123, or other user supplied programs.
4.5 Analog Output
The Honeywell
Honeywell | 19 |