Configuration

Note You can set up motion zones one block at a time in groups of 8 or 16 individual block groups (8- and 16-channel DVR respectively). Move a block group within the image area using the UP and DOWN arrows. Select and clear individual blocks within the block groups using the camera buttons.

 

Table 3-12

Motion Detection Zone Setup Screen Menu

 

 

Select

Activates highlighted blocks to detect motion.

 

 

Clear

Deactivates highlighted blocks so that they do not detect motion.

 

 

Reverse

Activates inactive highlighted blocks and deactivates active highlighted blocks.

 

 

Select All

Activates all blocks to detect motion.

 

 

Clear All

Deactivates all blocks so that they do not detect motion.

 

 

Reverse All

Activates inactive blocks and deactivates active blocks.

 

 

OK

Accepts changes and closes Zone setup.

 

 

Cancel

Exits Zone setup without saving changes.

 

 

 

Changing the Number of Motion Detection Blocks

You can adjust the minimum number of detection blocks that must be activated to trigger a motion alarm.

1.Highlight the field under the Min. Blocks heading in the Motion Detection Settings screen and press . The Motion Detection Min. Blocks screen appears.

2.Use the UP and DOWN arrows to independently adjust the minimum number of detection blocks for Daytime and Nighttime.

Smaller numbers provide greater sensitivity because fewer detection blocks must be activated.

Watching How the DVR Reacts to Motion

Turn Zone View On in the Motion Detection Settings screen to observe how the DVR reacts to motion. When in the motion viewing mode, any detected motion within the zone displays in red.

Adjusting the Motion Ignoring Interval

You can control excessive event logging and remote notification of motions detected after the motion dwell time by adjusting the motion ignoring intervals.

Document 800-00918 Rev F

83

02/08