Assembly

Step 2: Install Wheel Axle and Wheels

To install wheel assembly, you will need:

￿Wheel axle (1)

￿M8 x 16 mm long full-thread hex bolts (4)

￿M8 serrated flange nuts (4)

￿Axle bracket* (1)

￿Wheels (2)

￿M16 x 30 mm OD x 2.5 mm washers (2)

￿Cotter pins (2)

￿12 mm open end wrench

￿Socket wrench with 10 mm socket

￿Needle-nose pliers

* Two brackets are needed to install wheel axle. One bracket comes already attached to wheel axle; other bracket is included in wheel kit box.

Not included.

1.Install wheel axle brackets to frame using 16 mm long full-thread hex bolts and serrated flange nuts.

1A. Install pre-attached bracket to frame first.

1B. Install other bracket (included in hardware bag) to frame.

FIGURE 7: Wheel Axle Attached to Generator

On each end of axle:

2.Slide and push wheel onto axle.

FIGURE 8: Slide Wheel onto Wheel Axle

3.Slide 9/16" washer onto axle.

4.Slide cotter pin into pre-drilled hole until fully seated.

5.Using needle-nose pliers, bend each end of cotter pin in opposing directions to secure wheel to axle.

FIGURE 9: Cotter Pin Installation

6.Return generator to upright position (so that wheels and leg supports are touching the ground).

8

www.honeywellgenerators.com

HW7000EH Portable Electrical Generator Owner’s Manual

Page 14
Image 14
Honeywell HW7000EH owner manual Install Wheel Axle and Wheels, To install wheel assembly, you will need