Assembly

Step 1: Install Support Legs

To install support legs, you will need:

￿M8 x 30 mm long full-thread hex bolts (2)

￿M8 x 22 mm OD x 1.5 mm washers (2)

￿M8 serrated flange nuts (2)

￿M8 x 16 mm long full-thread hex bolts (4)

￿Support legs (2)

￿Rubber stoppers (2)

￿Socket wrench with 10 mm socket* * Not included

CAUTION

Generator must be empty of engine oil and fuel.

Drain engine oil and fuel, if necessary.

Generator is heavy! Lifting generator can cause back or other bodily injury. NEVER lift generator without assistance.

1.Place generator on a flat, level surface.

2.Stand at side of generator opposite recoil starter handle. Grip frame; carefully pull up and push to tilt generator backward.

5.Attach a rubber stopper to the bottom of each support leg using a 30 mm long full-thread hex bolt and a ser- rated flange nut; tighten until securely seated.

FIGURE 5: Rubber Stopper Attached to Support Leg

6.Attach each support leg to pre-drilled holes on bottom of generator frame, using 16 mm long full-thread hex bolts; tighten until securely seated.

FIGURE 6: Support Leg Attached to Generator

FIGURE 4: Tip onto Generator Recoil Side

3.Gently set generator onto the recoil side or elevate the generator by placing solid wood pieces under- neath unit.

4.Place a washer in the center of each rubber stopper.

HW7000EH Portable Electrical Generator Owner’s Manual

www.honeywellgenerators.com

7

Page 13
Image 13
Honeywell HW7000EH owner manual Install Support Legs, To install support legs, you will need