Assembly

Step 3: Install Handle Assembly

To install handle assembly, you will need:

￿Handle brackets (2)

￿Handle bars (2)

￿Pins (2)

￿Chains (2)

￿Rubber handle grips (2)

￿M6 x 40 mm long flange-head hex bolts (6)

￿M6 serrated flange nuts (6)

￿Socket wrench with 10 mm socket*

￿10 mm open end wrench*

* Not included

1.Hold handle bracket over pre-drilled holes on frame as shown in Figure 10.

FIGURE 10: Handle Bracket to Frame

2.Attach bracket to frame using 40 mm long flange- head hex bolts and serrated flange nuts and tighten.

3.Slide handle bar through center of each bracket and line up bolt holes.

FIGURE 11: Insert Handle Bar to Bracket

4.Attach handle to each bracket using 40 mm long flange-head hex bolt and serrated flange nut to hole closest to frame and tighten.

NOTE:

Handle should be in a horizontal position after tightening bolts and nuts. If handle seems to hang down, tighten bolts and nuts further.

5.Attach pin to chain.

FIGURE 12: Attach Pin and Chain

6.Attach chain to handle bracket as illustrated below. Insert pin through bracket and handle.

FIGURE 13: Attach Chain to Handle Bracket

7.Slide rubber handle grip onto each handle bar and push to achieve snug fit.

FIGURE 14: Attach Grips to Handle

Once properly installed, the handles can be collapsed, if desired, by removing the pins.

CAUTION

Hands and fingers can be pinched from collapsible handles.

Keep hands and fingers clear from hinges when collapsing generator handles.

Handles should only be used to roll the generator to a new location. If lifting the generator (i.e. into a vehicle), never use the handles to support the complete weight of the generator.

To collapse handles, remove pins and push firmly down on handle until it rests vertically against genera- tor frame.

To return handles to horizontal position, pull up on handle and lock with pins.

HW7000EH Portable Electrical Generator Owner’s Manual

www.honeywellgenerators.com

9

Page 15
Image 15
Honeywell HW7000EH owner manual Install Handle Assembly, To install handle assembly, you will need