How to Remap a Key Sequence

1.Select the modifier key from the Modifier Mode options.

2.Select the key to be remapped from the Key pulldown list.

3.Select Key Sequence from the Remapped Key pulldown list.

4.Select the first key for the multiple key sequence from the pulldown list.

5.Press the Add button to add the key to the multiple key sequence shown in the Key Sequence box. Repeat this step until all keys desired have been added to the key sequence. If necessary, use the Clear button to erase all entries in the Key Sequence box.

6.Click OK to save the result and close the Keypad Control.

Note: A key can only be used once in a multiple key sequence. For example, an F1 key added to a key sequence means an F1 key cannot be used again in the same key sequence.

Remap a Key to a Sequence of Unicode Values

Up to 16 Unicode values may be specified for the key sequence. The sequence can consist of keys and Unicode values.

1.Select the modifier key from the Modifier Mode options.

2.Select the key to be remapped from the Key pulldown list.

3.Select Key Sequence from the Remapped Key pulldown list.

4.Select Unicode from the Key Sequence pulldown list.

5.There are two Unicode text boxes located on the lower part of this tab. Enter the Unicode value in the left textbox and the Unicode character is displayed in the right textbox.

6.Press the Add button to add the key to the multiple key sequence shown in the Key Sequence box.

7.Repeat this steps 4 through 6 until all desired characters have been added to the key sequence. If necessary, use the Clear button to erase all entries in the Key Sequence box.

8.Click OK to save the result and close the control panel.

4-105