| Parameter | Function | |
|
| |
| The ports are disabled until the HX2 | |
Port | Bluetooth and Port 2 defaults to Ring when a Bluetooth enabled HX2 with ring scanner/imager is | |
| powered On | |
|
| |
| Default: Enabled. | |
Send Key Messages | When Send Key Messages (WEDGE) is checked any data scan is converted to keystrokes and sent | |
to the active window. When this checkbox is not checked, the application will need to use the set of | ||
(WEDGE) | ||
Scanner APIs to retrieve the data from the scanner driver. Note that this latter method is significantly | ||
| ||
| faster than using Wedge. | |
|
| |
| Default: Enabled. | |
Enable Scanner | Rejected bar codes generate a bad scan beep. In some cases, the receipt of data from the scanner | |
Sound | triggers a good scan beep from an external scanner, and then the rejection of scanned bar code data | |
| by the processing causes a bad scan beep from the HX2 on the same data. | |
|
| |
Imager LED | The default setting is Internal illumination. The imager has a bank of three LEDs above the imager | |
aperture that illuminate when External or Both radio buttons are enabled. The illumination turns off | ||
Illumination | ||
when the scan is complete. | ||
| ||
|
| |
| Single Scan determines if scanner input is inhibited after a scan until the scanner is | |
| Off - Single Scan mode is off. | |
| Auto - Single Scan mode is on. The scanner is disabled after a scan and automatically | |
| the scanner driver after retrieving the bar code data. | |
Single Scan | Man - Single Scan mode is on. The scanner is disabled after a scan and the user application must | |
| call LXEScannerSSReset to | |
| details. | |
| This option is only supported on Symbol (Motorola) internal and BTRS scanners. The scanner may | |
| require a firmware upgrade to support this feature. Contact Technical Assistance for details. | |
|
|
Click here to view factory default settings for this panel.