USB Port

This USB Port is full-speed and 2.0 compliant. Using a USB cable, you can connect the base to a peripheral device, such as a workstation or printer. When the terminal is seated in the terminal well, it is connected to the peripheral device via the base.

RS232 Port

Use the 9-pin, RS232 cable from Honeywell to connect this port to a peripheral device for RS232 data communication. For more information, see Serial Connector on page 12-4.

DC Power Jack

Use the power cable from Honeywell that comes with the base to supply power to this power jack. For more information, see Power section that follows.

Power

The terminal requires 9.5 Volts DC input for communications and battery charging; the power adapter on the power cable converts the voltage from the power source to 9.5 volts DC. Use only UL listed power supply, which has been qualified by Honeywell, with output rated at 9.5V and 4.0 amps with the device.

Honeywell recommends that you leave the base connected to its power source at all times, so that it is always ready to use.

1.Connect the power cable to the DC jack on the rear panel of the base.2.Connect the power cable to the power adapter.3.Plug the power adapter cable into the power source. The base is now powered.Serial Connector

The following diagram displays the pin diagram of the serial connector of the base.

Pin

Description

 

 

 

 

1

Internal Jumper to Pin 6

 

 

2

TXD

 

 

3

RXD

 

 

4

DSR

 

 

5

GND

 

 

6

DTR

 

 

7

CTS

 

 

8

RTS

 

 

9

RI

 

 

Note: Signals referenced are for a DTE device. The base is at a right-angle to the printed circuit board (PCB). The ninth pin has a ring indicator (RI).

12 - 4