9
9
NOTE:
1. Avoid pressing any buttons on the main unit before the remote
temperature is displayed.
2. The effective operating range may be influenced by the surrounding
building materials and how the rec eiver and transmitter are positioned.
3. Place the remote sensor so that it fac es the main unit (receiver),
minimizing obstructions such as doors, walls, and furniture.
4. Though the remote sensors are w eather-resistant, they should be
placed away from direct sunlight, r ain or snow. The best suggested
location for the remote sensor for outdoors is under the eave on the nor th
side of the building.
NOTE: When the temperature f alls below freezing, the batteries in
the outdoor remote sensor may have reduced volt age supply and a
shorter effective range. We recommend using lithium batteries at
temperatures of 32°F (0°C) and below.
REMOTE SENSOR
NOTE: Install the batteries; select the channel and temperature in C°
or F° before mounting the remote sensor .
· Remove the screws from the batter y compartment with a small
Phillips screwdriver.
· Set the channel. The switch is located in the batter y
compartment. Channel 1 is typically selected if only one remote
sensor is being used.
· Install 2 “AA” size alkaline batteries ( not included) matching the
polarities shown in the battery compar tment.
· Replace the battery compartment do or and secure the screws.
· Secure the remote sensor in the des ired location.
10
MAIN UNIT
· Open the battery compartment door .
· Install 4 batteries (UM-3 or “AA” siz e 1.5V) matching the polarity
as shown in the battery compar tment.
· Replace the battery compartment door.
A low-battery indicator [ ] will appear on the indoor or remote
temperature reading line of the main unit warning that the corresponding
batteries need replacement.
After batteries are installed; remote s ensor will transmit temperature
readings at 45 second intervals . It may take up to two minutes to rec eive
the initial readings. Upon succes sful reception, remote temperature w ill
appear in the temperature window below the weather forecast on the
main unit’s display (the default remote c hannel is channel one). The main
unit will automatically update readings .
After communication between t he main unit and remote sensor has
been established, secure the remot e sensor in the desired location.
If no signal is received from the r emote sensor within two minutes,
dashes [- - -] will be displayed. Press and hold the main unit DOWN (▼)
button for two seconds to initiate another signal search for the remote.