Honeywell Smoke Alarm installation instructions

2.Mount the IPDACT onto the IPBRKT using the plastic standoffs that came with the IPBRKT. Screw the standoff through the holes on the IPDACT into the metal mating threaded standoffs on the IPBRKT. Note, discard any double sided tape plastic standoffs that may be included with the IPDACT and use the supplied machine screw versions.

3.Connect 24 VDC from the non-resettable power output of the control panel to the IPDACT terminals marked "GND" and "+12/24VDC". Be careful to observe correct polarity! Run the two conductor power supply wire through the small ferrite ring supplied with the IPDACT.

5/19/2008 3 of 15