Manuals / Honeywell / Household Appliance / Smoke Alarm

Honeywell Smoke Alarm installation instructions Installation using IPENC or HP300ULX

Models: Smoke Alarm

1 15

Download 15 pages 48.03 Kb

Page 5

2. Installation using IPENC or HP300ULX

2. Installation using IPENC or HP300ULX

The IPENC is used for mounting the IPDACT next to panels that cannot accept the IPBRKT directly inside the enclosure. Examples of these include the MS- 9200UD and MS-9600.

Install the IPDACT onto the factory mounted IPBRKT inside the IPENC using the 4 supplied ¼”X 6-32 machine screws as shown below. The four black screws will be used to secure the enclosure door following IPDACT wiring connections.

For complete information of all installation options, follow the wiring instructions found in the included Product Installation Document.

Mount the IPENC next to the FACP as shown in the drawing below.

Mounting the IPBRKT inside the HP300ULX when more power is required

5/19/2008

5 of 15

Image 5

Honeywell Smoke Alarm Installation using IPENC or HP300ULX, Mount the IPENC next to the FACP as shown in the drawing below

Contents

Parts List Application Note Fire-Lite IPDACT Setup for Installing DealersInstallation Instructions for use with HyperTerminal and serial port Part Numbers1. Using Common Enclosure Connect the IPDACT to the fire panel Checklist of required programming information from Central Station2. Mount the IPDACT onto the IPBRKT using the plastic standoffs that came with the IPBRKT. Screw the standoff through the holes on the IPDACT into the metal mating threaded standoffs on the IPBRKT. Note, discard any double sided tape plastic standoffs that may be included with the IPDACT and use the supplied machine screw versions Connect serial cable here CN1 Mount the IPENC next to the FACP as shown in the drawing below 2. Installation using IPENC or HP300ULX4. Wire the IPDACT as described in the Product Installation Document Returning the IPDACT to factory default settings Programming Instructions Using HyperTerminal2. Short jumper P2 on the IPDACT using the supplied jumper Run HyperTerminal5/19/2008 Set Connect using to COM1 then OK8 of Set Port Settings to Bits per second Data bits Parity none Stop bits 9 ofPress Enter and the word password should appear as shown below Key-in default IPDACT password 24680 as shown above then press Enter5/19/2008 10 ofAt the menu options screen, shown below, select C Quick Install Quick Install i Select i Register MIP DHCP Theory of Operation The IP settings in the IPDACT work like this Option “g IP Connectivity” displays the IP settings that are running in the device