clock is programmed to search for the atomic time signal daily each hour between 1:00 am and 4:30 am. Once the time signal has been successfully received, the time and date will be updated automatically.
To manually enable or disable the atomic time receiver:
•Press and hold UP arrow button - if atomic time reception is activated, a triangular tower icon will start flashing next to the clock icon. If reception is disabled, the triangular tower icon will disappear.
Remote Sensor Status
The wave icon above the current channel display shows the connection status of the corresponding remote sensor:
Activate Search for Remote Sensors
Normally the main display will automatically find and display measurement results from the remote sensors. However, occasionally other radio transmission sources (TV, Cordless or Cell Phones etc) can interrupt the sensor signal. If this happens simply press and hold the DOWN arrow button for 4 – 6 seconds to activate a new search.
Memory Reset Procedure
These steps will completely reset all of the parameters stored in memory.
•On the main unit press and hold SNOOZE and UP buttons for 4 seconds until the backlight will flash
•Press SET button clearing the memory
•Wait until the beeping will cease
•Disconnect main unit from the AC/DC adapter and remove the batteries from the back of the main display unit and wait 10 seconds
•Reinstall the batteries and reconnect the main unit to the wall power outlet through the AC/DC adapter
26
