E. WIND CUPS SHAFT
Holds wind cups on the anemometer arm
F. BATTERY COMPARTMENT
Holds 2
G. WALL MOUNT SCREW OPENINGS
Allows securing the anemometer in place
H. BATTERY COVER
Allows securing 2 AA size batteries on the anemometer base
Assembly
•Place the wind cups over the wind cups shaft of the anemometer arm
•Insert the wrench tool provided into the wind cups opening and tighten the small screw inside.
•Test if the wind cups sit secure on the wind cups shaft
Battery installation
•Remove four (4) screws from the battery compartment with a small Phillips screwdriver.
•Open the battery compartment and install 2 “AA” size alkaline batteries (not included) matching the polarities shown.
•Replace the battery compartment door and secure the screws.
Aligning
•Point the wind direction vane to the north (use a compass or map if necessary).
•Press “SET” opening located inside battery compartment with a paper clip or similar tool. The “SET” opening controls toggling the wind direction between the factory preset or user set.
•Select the factory set mode. It will be also a default setting in the future.
•Set current wind direction as NORTH.
Note: Repeat this procedure every time when changing the batteries.
Mounting
Mount the anemometer onto a vertical surface, using the fittings provided.
Placement tips:
•The anemometer should be mounted in an open area with a free air flow; away from the nearby trees, buildings or other structures.
•Aim for a maximum exposure of the anemometer to the most common wind directions in the area.
•It is suggested mounting anemometer at 33 feet (10meters) above the ground in unobstructed area.
14
