Thermo-Hygrometer Sensor
FEATURES
•Remote data transmission to the main unit via 433 MHz signal
•328 feet (100 meters) transmission range without interference
•LCD display of measured temperature and humidity
•Five (5) transmission channels selection
•Case can be wall mounted using
A. LED INDICATOR
•Flashes once when the remote sensor transmits a reading to the main unit.
•Flashes twice when battery power is low.
B. BATTERY COMPARTMENT
Holds two
C.RESET Resets all readings
D.CHANNEL SWITCH
Selects the desired channel from 1 to 5
E.WALL-MOUNT RECESSED OPENING Keeps the remote sensor on the wall
Note: Install the batteries and select the channel before mounting the sensor.
Battery installation
•Remove the screws from the battery compartment with a small Phillips screwdriver.
•Set the channel 1 through 5. The switch is located in the battery
compartment. Channel 1 is typically selected if only one remote sensor is being used.
•Install 2 “AA” size alkaline batteries (not included) matching the polarities shown in the battery compartment.
•Replace the battery compartment door and secure the screws.
•Secure the
Mounting
9