Viewing Rain Statistics
In the Rain Mode, press either SET or MEMORY button to recall a rain statistics for the past hour, past 24 hours, yesterday, past week or past month.
Tip: For the rain rate estimate the Last Hour rainfall value is understood as “inch/hr” or “mm/hr”.
Resetting the Rainfall Statistics Memory
In the Rain Mode, press and hold MEMORY to reset all rainfall statistics.
Setting Units for the Rain Display in inches or mm
In the Rain Mode, press and hold SET button to toggle rainfall data units between mm and inches.
Enabling or Disabling the Daily Rainfall Alert
•In the Rain Mode press the ALARM/CHART to display either the current rainfall statistics or the daily rainfall alert with “ALARM HI” displayed.
•If the alert is disabled, the “OFF” will be displayed; otherwise the rainfall alert value will be shown.
•When the rainfall alert is displayed, press the UP or DOWN to enable or disable
it.
Setting up the Daily Rainfall Alert
•In the Rain Mode, press ALARM/CHART to display the rainfall alert.
•Press and hold ALARM/CHART until the rainfall alert “ALARM HI” will flash.
•Set the desired value for the Rainfall Alert by using the UP or DOWN. Press and hold either button for fast digits advance.
•Press ALARM/CHART to confirm selection and the unit will return to the rainfall alert display.
Disabling the Daily Rainfall Alert
In the Daily Rainfall Alert Mode press the ALARM/CHART to disable the alert.
Wind Mode
The wind direction is shown by an animated compass display. Its angle can be displayed as compass points (i.e. NW) or in bearings starting from north (i.e. 22.5º).
The upper left section of the wind mode can be programmed to display either a temperature at the place of anemometer or the temperature adjusted to the wind chill factor.
The lower left section of the wind mode indicates the average wind speed for the past 10 minutes, as well as gust, wind speed alert and gust alert information. It can also show records of the maximum wind speed and wind gust collected during the day.
35
