Using the Keyswitch
General
Your system may be equipped with a keyswitch for use when arming and disarming a partition. A red and green light on the keyswitch plate indicate the status of your system as follows:
Green Light: Lights when the system is disarmed and ready to be armed (no open zones). If the system is disarmed and the green light is off, it indicates the system is not ready (one or more zones are open).
Red Light: Lights when system is armed or memory of alarm exists.
Lit Steady: Partition is armed in AWAY mode.
Slow Flashing: Partition is armed in STAY mode.
Rapid Flashing: Memory of alarm, indicating an alarm has occurred.
Arming
To arm in the AWAY mode, turn the key to the right for 1 second and release. Keypads will beep twice and the
red light will stay on steady.
To arm in the STAY mode, turn the |
|
|
|
|
|
key to the right and hold for longer than |
|
|
|
|
|
10 seconds, then release. Keypads will |
|
|
|
|
|
beep three times and the red light will GREEN |
|
|
|
| RED |
flash slowly. |
|
|
|
|
|
Disarming |
|
|
|
|
|
|
|
|
|
| |
To disarm the partition, turn the key |
|
|
|
|
|
to the right and release. If an alarm has |
|
|
|
|
|
occurred, the red light will be flashing |
|
|
|
|
|
|
|
|
|
| |
rapidly (memory of alarm). |
|
|
|
| |
|
|
|
|
|
NOTE: Your system may be programmed to use the keyswitch to silence fire alarms without affecting the status of the burglary portion of the system. Check with your installer to see if this feature has been enabled.
– 40 –
