HOW TO REPLACE
THE BELT
1.Turn cleaner over. Remove metal plate on bottom of cleaner by pushing latches toward the out- side of cleaner. Lift plate to re- lease it from wire holders.
2.Push latches, that hold agitator, in and toward center of cleaner until they are free. Lift out agitator and remove old belt.
3.Place new belt over motor pulley, with smooth side next to pulley, then over agitator.
4.Replace agitator and latch it in position.
5.Make sure that belt is in center of pulley and free of agitator mountings and latch. Turn agitator by hand to be sure that belt is in proper position in pulley groove.
6.R e p l a c e b o t t o m p l a t e . P l a c e metal knobs, on front of plate, in wire holders. Check to see that latches are pushed back and will not be covered by plate. Place plate in position and latch se-
cure ly . Turn agitator by hand to be sure that belt is in proper position on pulley .
6
