2.After plate is removed, pry out the end section as shown in illustration.
3.After plate is removed, tap the shaft gently with a hammer.
4.Pull other plate and the shaft from agitator.
5.Remove brushes by pull- ing them from agitator. If they do not come out easily, pull them out with pliers.
&Install new brushes by sliding them into the channel, making sure that the small end goes in first. Push in as far as possible.
7.Replace end plate and shaft. Remember to line up locator with the slot on the agitator. Replace other end section and end plate and then tighten.
13