9
3-10
3-6
3-5
3-7
3-8 3-9
3-11
Pull up on pre-filter assembly. Slide it out
of cup.
Replace dirt cup.
Filter assembly

How to clean filter

assembly

Remove dirt cup and dirt cup lid as
described in “How to empty dirt cup”.
Pivot pre-filter assembly toward center of
cup.
Remove pleated filter from pre-filter
assembly.
The screen (C) can be cleaned with a
soft brush or rinsed with water.
Do not rinse or wash the pleated filter.
Slide pre-filter assembly all the way to
bottom of cup.
Pivot pre-filter assembly and snap in
place.
Replace dirt cup lid.
If lid will not close completely, the
pre-filter assembly is not positioned
correctly.
Lay filter on top of pre-filter. Make sure
all filter pleats are inside the edges of
the pre-filter. Press on filter gasket (F)
until 4 tabs (G) (2 on either side of filter)
are set in the slots (H) on the pre-filter.
Be careful not to press the filter gasket
below the pre-filter edge.
Bend filter to open pleats.
Tap edges of filter until dust particles
stop falling from filter.
Do not tap the soft, pleated part of the
filter. It could damage the filter.
G
F
C