B
With cord hook (B) to back of cleaner, push upper handle down onto cleaner. Insert screw with washer in front of tank area. Tighten screw with a Phillips screwdriver.
Insert two screws into back of handle as shown. Tighten with a Phillips screwdriver.
Replace clean solution tank by posi- tioning bottom first. Press latch and snap top portion into place.
D |
E
C
F
To install brushes, place handle in upright position. Tilt cleaner back so that it rests on the floor.
Align post (C) on brush block with hole (D) on bottom of cleaner. Turn brushes slightly until post fits easily into hole.
Press brush assembly firmly to snap into place.
To install nozzle, make sure latches are out.
Align middle section (E) of nozzle with opening (F) on cleaner.
Remove cardboard packing insert from squeegee area on underside of nozzle.
While holding nozzle in place, slide latches inward to lock in place.
4
