3-11
Using the scrub tool
With a little solution, test the scrub tool on a hidden area before using on the desired surface. If no surface change is visible, continue to use as described below.
1.Fill clean solution tank with HOOVER Bare Floor Cleaner according to instruc- tions for Figs.
2.Hold scrub tool above area to be
cleaned and press trigger to dispense solution.
3.Release trigger and scrub area with tool. Pick up dirty solution with squeegee as shown.
3-12
G
After using scrub tool
To clean scrub pad, pull it off module. Wash it in water with mild detergent. Rinse and let air dry.
Pad must be completely dry before reat- taching to module and storing on deep cleaner.
Replacement pads may also be pur- chased. Ask for HOOVER part no. 40308001.
To store scub module , remove scrub module from tool in same manner as removing the brush module.
Align openings on back of module with tabs in storage area (G).
Push module into position.
3-13
After using tool
1.Follow steps a and b for “After clean- ing” on pages 9 & 10.
2.Rinse tool and hose by filling sink with a small amount of water. Turn
deep cleaner ON and pickup the water with the tool.
3-14
3.Drain hose by turning deep cleaner ON and holding end of hose up for sev- eral seconds. Do not press trigger.
4.Disconnect deep cleaner from electri- cal outlet.
5.Drain solution tube (located inside hose) by pointing end of hose in sink and pressing trigger.
6.Proceed with steps c, d, and e, for “After cleaning” on pages 9 & 10.
Cleaning carpeted stairs
Read “Before you begin cleaning” instructions on page 9.
1.Place handle in upright position.
Agitator brushes will not rotate while handle is in upright position.
2.Fill clean solution tank with HOOVER Carpet/Upholstery Detergent according to instructions for Figs.
3.Attach tool to end of hose.
4.Hose length may require that machine be placed at the top of the stairs to clean upper half of stairway and at bot- tom of stairs to clean lower half.
To prevent machine from falling, use extra caution when cleaning on stairs.
Do not place deep cleaner on stairs.
Do not point tools toward people or pets.
5.Dry hands and plug deep cleaner into a properly grounded outlet.
6.Turn deep cleaner ON. If necessary, refer to “Before using tool” section to remove air from the system.
3-15
A
B
7.
8.Position tool against the riser and slightly press it into carpet pile. Press the trigger and pull the tool s l ow ly over the carpet (second wet stroke). Release trigger at end of stroke.
12
