2.Pull old bulb straight out of socket.
3.Push new bulb straight into socket until locked into place.
Excessive fo rce is not required.
Reposition lens and secure with scre w.
Removable brushes
Your deep cleaner is equipped with removable brushes for easy cleaning.
To remove brushes
Disconnect cleaner from electrical outlet.
To prevent possible leaking, remove clean solution tank and recovery tank. Set tanks aside.
Press handle release pedal to lower han- dle. Turn cleaner over so bottom is fac- ing up.
4-4 B
AB
Grasp inner portion of brush (A) and pull brush assembly out slightly to reveal latches (B).
4-5 B
B
Press both latches (B) and pull brush block out. The brushes can be cleaned under running water.
C | D | |
|
|
F
E
D
C
To replace brushes
Align posts (C) on both ends of brush assembly with slots (D) in cleaner hous- ing.
Make sure that the square post (E) also aligns with the square hole (F). Turn brushes slightly until post fits easily into hole.
Press brush firmly to snap into place.
S t o r a g e
Before storing:
•Empty solution tank and rinse thoroughly with clean water.
•Replace empty solution tank and turn deep cleaner ON. Squeeze trigger and push deep cleaner for- ward and back several times to expel any solution remaining in the deep cleaner’s system. (Do not use deep cleaner on wood floors.)
•Empty recovery tank and rinse thoroughly with clean water.
Allow brushes and underside of deep cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood surface.
Do not store deep cleaner with a full solution tank in place.
Lubrication
The motor is equipped with bearings which contain sufficient lubrication for the life of the motor. The addition of lubri- cant could cause damage. Do not add lubricant to motor bearings.
14
