3-16
A
B
9.Lift tool, and position it against riser. Pull tool slowly over carpet without pressing trigger (dry stroke).
It is best to alternate wet and dry strokes as described above. End with more dry strokes and watch for the green ‘MAX Extract’ light to come on to aid in faster drying of carpet.
10.Overlap strokes by 1/2 inch to help prevent streaking.
To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Always end with dry strokes.
If additional cleaning is necessary, wait until the carpet is completely dry before using the tool again.
11.Empty recovery tank when the red ‘MAX Extract’ light comes on and the motor sound becomes higher pitched and there is a loss in suction (see “Automatic
When finished cleaning, follow “After cleaning” instructions on page 9 and “After using tool” instructions on page 12.
Cleaning upholstery
Read “Before you begin cleaning” instructions on page 9.
Be sure to check the cleaning code on your upholstery. Use your deep cleaner only on upholstery marked “W”or “W/S”.
1.Place handle in upright position.
Agitator brushes will not rotate while handle is in upright position.
2.Fill clean solution tank with HOOVER Carpet/Upholstery Detergent according to instructions for Figs.
3.Attach tool to end of hose.
Do not point tools toward people or pets.
4.Dry hands and plug deep cleaner into a properly grounded outlet.
5.Turn deep cleaner ON. If necessary, refer to “Before using tool” section to remove air from the system.
6.Gently press the tool onto the fabric. Press the trigger and slowly pull the noz- zle over the fabric.
7.Overlap strokes by 1/2 inch to help prevent streaking.
3-17
Make additional strokes without pressing the trigger to remove more moisture. Also, periodically checking the ‘MAX Extract’ lights will help ensure that the maximum amount of water has been removed.
8.To clean in corners or creases, lift the tool
9.Vacuum up the solution with the tool without pressing the trigger.
10.For heavily soiled areas, it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original pattern; overlap each pass.
| 4. Maintenance | |
|
| |
|
|
|
H e a d l i g h t
re p l a c e m e n t
What to buy
The deep cleaner uses a 7 volt, wedge base type bulb, H O OVER part no.
2 7 3 1 3 1 0 6 .
Make no more than 2 passes with the solution over any one area to prevent
If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again.
11.Empty recovery tank when the red ‘MAX Extract’ light comes on and the motor sound becomes higher pitched and there is a loss in suction (see “Automatic
When finished cleaning, follow “After cleaning” instructions on page 9 and “After using tool” instructions on page 12.
W h e re to buy
Bulbs may be purchased from authorized Hoover dealers (Depot), Hoover Factory S e rvice Centers, or through The Hoover Company online at www. h o o v e r. c o m .
How to re p l a c e
Turn cleaner off and with dry hands, disconnect deep cleaner from electri- cal outlet.
1.Using a Phillips scre w d r i v e r, re m o v e the screw as shown and lift off lens.
Continued ➜ 13
