Hoover SpinScrub Assemble handle, Attach upper handle, Attach hose holder, Attach tool holder

The assembled cleaner will look like this drawing.

Assemble handle

1-2

Attach upper handle

Remove clean solution tank (upper tank) from deep cleaner.

1-3

A1

A2

With hose hook (A1) and cord hook (A2) to back of deep cleaner, push upper handle down onto lower handle. Push b o l t s into holes on f ront of handle. If bolts will not go through hole easily handle is not pushed completely dow n .

1-4 1-5 1-6

B

D

C

Attach hose holder

Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure holes for bolts are aligned.

1-7

Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.

4

Place nuts in recessed areas on back of handle. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screw driver.

Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience.

1 - 8

Attach tool holder

Remove tool and taped screw from holder.

Insert projections on holder into slots on back of cleaner.

When handle sections are completely together, squeeze trigger (C) and depress Clean Surge™ Button (D) on upper handle.

You will hear a “snap”when the trig- ger rod is in place.

1 - 9

E

Slide rack down into place. Insert screw at (E) and tighten with a Phillips screw- driver.