The headlight
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part
No.
How to replace
Disconnect cleaner from electri- cal outlet and detach hose from cleaner.
1.Remove nozzle control knob on front of hood by grasping knob and pulling up.
2.Place handle in operating position and turn cleaner over. Insert end of flat screwdriver into one of the four slots beside an arrow on bottom of cleaner.
3.Pry outward to release latch. Repeat to release latches at the remaining three arrows.
4.Turn cleaner over and lift off hood.
Do not lift cleaner by grasping the wheels in center of cleaner body.
5. Remove bulb by pulling straight out of socket; push new bulb into socket until it locks in place.
|
|
|
|
| ➘ | 6. Place hood on cleaner body and | |
|
| ||
|
|
| press firmly to snap all four latches. |
|
|
| Pull up on hood slightly to make |
|
|
| sure all four latches are secured. |
|
|
| Push nozzle control knob back onto |
|
|
| front of cleaner. |
|
|
|
|
The belt
The belt on your HOOVER cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the cleaner and should be checked from time to time to be sure it is in good condition.
When to replace
To check belt, remove bottom plate as shown on the following page under “How to replace.” Replace belt if it is stretched, cut or broken.
What to buy
One extra belt has been provided with your cleaner.
To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for Hoover part No.
19 | 20 |
