Push bolt into hole on lower front of handle. (Fig. 11)
If bolt will not go through hole easily , check the following:
•the bracket is properly positioned (see Fig. 9)
•the handle is pushed down completely (see Fig. 10)
Place nut in recessed area at back of handle. Hold nut in place while tightening bolt securely with a screw driver. (Fig. 12)
Only one nut is needed on this model. The extra nut is not required but has been provided for your convenience.
STEP 4: Attach bag compartment
Pull bag door latch forward and remove door. Set bag door aside. (Fig. 13)
Slide large tab on bottom of bag housing into slot between the bracket and the lower handle (Fig. 14).
7
11
BOLTNUT
12
NUT
13
BAG DOOR
LATCH
BAG DOOR
14
TAB
BRACKET
15
SLOTS
DIRT
HOOKSTUBE
BAG
COMPART-
MENT
16
BAG
COLLAR
DIRT
TUBE
17
18 |
TABS |
Note round opening and hooks on back of bag compartment.
Place opening over dirt tube and align hooks with slots in handle.
Push very firmly to snap hooks into handle. (Fig. 15)
Pull on bag compartment to make sure it is completely snapped to handle.
STEP 6: Attach paper bag
Align opening in paper bag with dirt tube insidebag compart- ment. (Fig. 16)
Push paper bag collar firmly onto tube. (Fig. 17)
Tuck top and bottom of paper bag into bag compartment.
To replace bag door, insert the 2 tabs on bottom of bag door into the 2 slots on bag compart- ment. (Fig. 18)
Make sure all edges of paper bag are completely inside the bag compartment.
Close door.
Continued ➜
8
