Horizon Fitness CX-66 manual Remove PRE-ATTACHED Bolts and Washers from Console Mast

INTRODUCTION IMPORTANT

PRECAUTIONS

ASSEMBLY

BEFORE

YOU BEGIN

ELLIPTICAL

OPERATION

CONDITIONING TROUBLESHOOTING LIMITED

GUIDELINES & MAINTENANCE WARRANTY

10

A S S E M B LY STEP 4
PEDAL ARM
PEDAL ARM COVER	SCREW (J)
SCREW (K)
ROLLER WHEEL COVER

A)Open HARDWARE BAG FOR STEP 4.

B)Attach the PEDAL ARM COVER using 1 SCREW (J).

C)Attach the ROLLER WHEEL COVER using 1 SCREW (K).

D)Repeat on other side.

HARDWARE BAG FOR STEP 4 CONTENTS :

SCREW (J)	SCREW (K)
15 mm	12 mm
Qty: 2	Qty: 2

A S S E M B LY STEP 5

PRE-ATTACHED BOLTS AND WASHERS

UPPER HANDLEBAR

CONSOLE MAST

PRE-ATTACHED SCREWS

LOWER HANDLEBAR

NOTE: There is NO hardware bag for this step. All hardware is pre-attached.

A)Remove PRE-ATTACHED BOLTS and WASHERS from CONSOLE MAST.

B)Slide right LOWER HANDLEBAR on CONSOLE MAST and attach by reinserting PRE-ATTACHED BOLT and WASHERS.

C)Remove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR

D)Slide right UPPER HANDLEBAR onto LOWER HANDLEBAR and secure by reinserting PRE-ATTACHED SET SCREWS

E)Repeat on other side.

After handlebars are assembled they will rotate freely – be cautious. Until the machine is fully assembled, do not grab the handlebars for support.

11

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

ELLIPTICAL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

CX-66_Elliptical_Rev.1.6.indd 10-11 6/13/07 1:26:28 PM