Horizon Fitness E6 14, 15, ASSEMBLY STEP 9, ASSEMBLY STEP 8

BEFORE
YOU BEGIN
14
INTRODUCTION IMPORTANT
PRECAUTIONS ASSEMBLY BEFORE
YOU BEGIN ELLIPTICAL
OPERATION LIMITED
WARRANTY
TROUBLESHOOTING
& MAINTENANCE
CONDITIONING
GUIDELINES
BEFORE
YOU BEGIN ASSEMBLY
15
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
ASSEMBLY STEP 9
PRE-ATTACHED SCREW
HANDLEBAR COVERS
RIGHT HANDLEBAR
ASSEMBLY STEP 8
A ) Open HARDWARE BAG FOR STEP 8.
B) Attach the OUTSIDE ELBOW COVER to the elbow joint using 1 SCREW (L).
C) Snap the INSIDE ELBOW COVER onto the OUTSIDE ELBOW COVER. Note the position of the snap tabs before
snapping into position.
D) Repeat on other side.
NOTE: There is NO hardware bag for this step. All hardware is pre-installed.
A) Remove PRE-ATTACHED SCREW from the RIGHT HANDLEBAR.
B) Snap HANDLEBAR COVERS together over the RIGHT HANDLEBAR. Note the position of the snap tabs on the
covers before snapping into position.
C) Attach HANDLEBAR COVERS with PRE-ATTACHED SCREW.
D) Repeat on other side.
SCREW (L)
OUTSIDE ELBOW COVER
INSIDE ELBOW COVER
SCREW (L)
30 mm
Qty: 2
HARDWARE BAG FOR STEP 8 CONTENTS :
E6_Rev.1.2.indd 14-15 8/7/06 4:43:39 PM