INTRODUCTION IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING GUIDELINES
A S S E M B LY STEP 6 |
LEFT HANDLEBAR |
|
RESISTANCE WIRES |
RIGHT HANDLEBAR |
NOTE: There is NO hardware bag for this step. All hardware is
A)Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B)Slide LEFT HANDLEBAR onto CONSOLE MAST and attach by
C)Repeat on other side.
D)Connect RESISTANCE WIRES from the RIGHT HANDLEBAR to the wires from the MAST.
A S S E M B LY STEP 7 | |
LOWER LINK ARM | LOWER |
| HANDLEBAR |
TEFLON WASHERS | |
| SPACER |
| LOWER HANDLEBAR |
| BOLT (G) |
| SPACER (H) |
LOWER LINK ARM | |
| SPACER RINGS (I) |
| WASHER (J) |
| NUT (K) |
| LOWER LINK ARM |
| GUIDE RAIL |
A)Open HARDWARE BAG FOR STEP 7.
B)Slide SPACER (H) into LOWER LINK ARM.
C)Place SPACER RINGS (I) on both sides of SPACER (H). While holding SPACER RINGS (I), slide LOWER LINK ARM into bottom end of LOWER HANDLEBAR.
D)Insert BOLT (G) into LOWER HANDLEBAR and secure using WASHER (J) and NUT (K).
E)Repeat on other side.
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
CONDITIONING GUIDELINES
TROUBLESHOOTING LIMITED & MAINTENANCE WARRANTY
12
|
| After handlebars are assembled they will rotate freely – be cautious. Until the |
| WARNING | |
| machine is fully assembled, do not grab the handlebars for support. | |
|
|
|
|
|
|
HARDWARE BAG FOR STEP 7 CONTENTS :
BOLT (G) 45 mm Qty: 2
SPACER RING (I) | WASHER (J) | |
20 mm | ||
18 mm | ||
Qty: 4 | ||
Qty: 2 | ||
|
SPACER (H) 28 mm axis Qty: 2
NYLON NUT (K) INSIDE DIAMETER: 8 mm
Qty: 2
13
LIMITED TROUBLESHOOTING WARRANTY & MAINTENANCE
E6_Rev.1.2.indd | 8/7/06 4:43:36 PM |
