INTRODUCTION IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL CONDITIONING TROUBLESHOOTING LIMITED
OPERATION GUIDELINES & MAINTENANCE WARRANTY
10
A S S E M B LY STEP 4 |
LEFT LOWER LINK ARM |
SPLIT TEFLON WASHERS (G) |
LEFT PEDAL ARM |
BOLT (I) |
FLAT |
WASHER (H) |
CONNECTING TUBE |
SPACER (F) |
AOpen HARDWARE BAG FOR STEP 4.
BAlign the
CSlide the SPACER (F) through the
DInsert 2 SPLIT TEFLON WASHERS (G) between the CONNECTING TUBE and the
ESecure the joint with a FLAT WASHER (H) and BOLT (I).
FRepeat on the other side.
HARDWARE BAG FOR STEP 4 CONTENTS : |
|
|
|
| SPACER (F) |
|
| 65 mm axis |
|
| Qty: 2 |
SPLIT TEFLON | FLAT WASHER (H) | BOLT (I) |
WASHER (G) | 35 mm | 15 mm |
28 mm | Qty: 2 | Qty: 2 |
Qty: 4 |
|
|
A S S E M B LY STEP 5 |
|
|
|
| LOWER LINK ARM | LOWER HANDLEBAR | |
| SPACER RINGS |
|
|
| SPACER |
| |
| LOWER HANDLEBAR |
| |
| SCREW (L) |
|
|
| NUT (N) | BOLT (M) | |
LOWER LINK ARM | TEFLON WASHER (K) SPACER (J) | SCREW (L) | |
AOpen HARDWARE BAG FOR STEP 5.
BSlide SPACER (J) into LOWER LINK ARM.
CPlace TEFLON WASHERS (K) on either side of SPACER (J). While holding TEFLON WASHERS (K) slide LOWER LINK ARM into bottom end of LOWER HANDLEBAR.
DInsert BOLT (M) into LOWER HANDLEBAR and secure using NUT (N).
EAttach the OUTSIDE ELBOW COVER to the ELBOW JOINT using 1 SCREW (L).
FSnap the INSIDE ELBOW COVER onto the OUTSIDE ELBOW COVER.
Note the position of the snap tabs before snapping into position.
GAttach the INSIDE ELBOW COVER to the ELBOW JOINT using 1 SCREW (L).
HRepeat on other side.
HARDWARE BAG FOR STEP 5 CONTENTS : |
|
|
|
SPACER (J) |
| TEFLON WASHER (K) | SCREW (L) |
44 mm |
| 28.4 mm | 15 mm |
Qty: 2 |
| Qty: 4 | Qty: 4 |
| BOLT (M) | NUT (N) |
|
| INSIDE DIAMETER: |
| |
| 60 mm |
| |
| 8 mm |
| |
| Qty: 2 |
| |
| Qty: 2 |
| |
|
|
|
11
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
LIMITED TROUBLESHOOTING CONDITIONING ELLIPTICAL WARRANTY & MAINTENANCE GUIDELINES OPERATION
E701_Rev.1.8.indd | 9/10/08 11:05:24 AM |
