INTRODUCTION
A S S E M B LY STEP 2
A S S E M B LY STEP 3 |
INTRODUCTION
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
CONSOLE MAST BOLTS (C)
SPRING WASHERS (D)
FLAT WASHERS (E)
CONSOLE MAST BOOT 
BOLTS (C)
MAIN FRAME
CONSOLE |
MAST |
WATER |
BOTTLE |
HOLDER |
SCREW |
CONSOLE | UPPER RIGHT | |
MAST | ||
HANDLEBAR | ||
| ||
WAVY WASHER & BOLT | ||
LOWER RIGHT | HANDLEBAR | |
HANDLEBAR | ||
| COVERS |
IMPORTANT PRECAUTIONS
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL CONDITIONING TROUBLESHOOTING OPERATION GUIDELINES & MAINTENANCE
AOpen HARDWARE BAG FOR STEP 2.
BSlide CONSOLE MAST BOOT onto the bottom of the CONSOLE MAST above bolt holes as shown.
CCarefully pull the CONSOLE CABLE through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
DAttach the CONSOLE MAST to the MAIN FRAME using 7 BOLTS (C), 7 SPRING WASHERS (D) and 7 FLAT WASHERS (E). Slide CONSOLE MAST BOOT down to cover main frame.
DO NOT PINCH WIRES!
E Attach the WATER BOTTLE HOLDER to the mast using 2
HARDWARE BAG FOR STEP 2 CONTENTS : |
|
|
BOLT (C) | SPRING WASHER (D) | FLAT WASHER (E) |
15 mm | 15 mm | 20 mm |
Qty: 7 | Qty: 7 | Qty: 7 |
NOTE: There is NO hardware bag for this step. All hardware is
ARemove PRE-ATTACHED BOLT & WASHER from CONSOLE MAST.
BSlide lower RIGHT HANDLEBAR onto CONSOLE MAST and attach by
CRemove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR.
DSlide right UPPER HANDLEBAR onto right LOWER HANDLEBAR and secure by reinserting
|
| After handlebars are assembled they will rotate freely – be cautious. Until |
| WARNING | |
| the machine is fully assembled, do not grab the handlebars for support. | |
|
|
|
|
|
|
ESnap the front and back HANDLEBAR COVERS together onto the HANDLEBARS. Note the position of the snap tabs on the covers before snapping into position.
FRepeat on other side.
TROUBLESHOOTING CONDITIONING ELLIPTICAL & MAINTENANCE GUIDELINES OPERATION
LIMITED |
|
|
| LIMITED |
WARRANTY |
| WARRANTY | ||
|
|
| ||
E701_Rev.1.8.indd | 9/10/08 | 11:05:15 AM | ||
