INTRODUCTION IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
CONDITIONING TROUBLESHOOTING HORIZON
GUIDELINES & MAINTENANCE WARRANTY
A S S E M B LY STEP 2 |
| |
BOLT (A) | CONSOLE MAST | |
SPRING WASHER (B) | ||
| ||
FLAT WASHER (C) | CONSOLE MAST BOOT | |
| ||
| CONSOLE WIRES | |
TOP FRONT COVER |
| |
| TOP BACK COVER | |
MAIN FRAME |
|
A)Open HARDWARE BAG FOR STEP 2.
B)Carefully pull the CONSOLE CABLES through the CONSOLE MAST using the twist tie located inside the
CONSOLE MAST.
C)Attach the CONSOLE MAST to the MAIN FRAME using 4 BOLTS (A), 4 SPRING WASHERS (B) and 4 FLAT WASHERS (C).
D)Insert the TOP FRONT COVER, followed by the TOP BACK COVER and snap them together.
E)Slide CONSOLE MAST BOOT down to seal the console mast hole.
DO NOT PINCH WIRES!
HARDWARE BAG FOR STEP 2 CONTENTS :
413*/(8"4)&3 # | ||
NN | NN | NN |
2UZ | 2UZ | 2UZ |
A S S E M B LY STEP 3 |
|
|
|
|
| UPPER HANDLEBAR |
|
|
|
| UPPER |
| NOTCH |
| HANDLEBAR |
|
|
| |
CONSOLE MAST | TAB | SET SCREWS | BACK |
|
|
| HANDLEBAR |
|
|
| COVER |
|
|
| FRONT |
|
|
| HANDLEBAR |
|
|
| COVER |
|
| LOWER | |
|
| BOLT & WASHER | |
|
| HANDLEBAR | |
|
|
| |
| LOWER HANDLEBAR |
|
|
NOTE: There is NO hardware bag for this step. All hardware is
A)Remove PRE-ATTACHED BOLT & WASHERS from CONSOLE MAST.
B)Slide LOWER HANDLEBARS onto CONSOLE MAST and attach by
C)Slide UPPER HANDLEBARS onto LOWER HANDLEBARS and align NOTCH with TAB making sure handlebars are joined together completely. Secure UPPER HANDLEBARS to LOWER HANDLEBARS using
D)Snap the front and back HANDLEBAR COVERS together onto the UPPER HANDLE BARS.
Note the position of the snap tabs on the covers before snapping into position.
E) Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the machine is fully assembled, do not grab the handlebars for support.
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
HORIZON TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
3/29/07 11:55:37 AM |
