INTRODUCTION

PROPER USAGE

 

 

 

 

 

 

 

 

Your treadmill is capable of reaching high speeds. Always start off using a slower speed and adjust the speed in

 

 

PRECAUTIONS

small increments to reach a higher speed level. Never leave the treadmill unattended while it is running. When

 

 

feel pain, faint, dizzy or are short of breath.

 

 

IMPORTANT

not in use, remove the safety key, turn the on/off switch to off and unplug the power cord. Make sure to follow

 

 

 

the MAINTENANCE schedule located on page 30 in this manual. Keep your body and head facing forward. Do not

attempt to turn around or look backwards while the treadmill is running. Stop your workout immediately if you

 

 

 

 

 

ASSEMBLY

 

 

 

Do not operate the treadmill if the power cord or plug is damaged.

 

 

WARNING

 

 

If the treadmill appears to not be working properly, do not use the treadmill.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

FOLDING

YOU

Firmly grasp the back end of the treadmill. Carefully

 

BEFORE

lift the end of the treadmill deck into the upright

BEGIN

position until the foot lock latch engages and

 

 

securely locks the deck into position. Make sure the

 

deck is securely latched before letting go. To unfold,

 

firmly grasp the back end of the treadmill. Gently

 

press down on the foot lock latch with your foot until

TREADMILL OPERATION

the lock latch disengages. Carefully lower the deck

to the ground. NOTE: The foot lock latch is located

 

on the bottom right side of the deck.

GUIDELINES

MOVING

 

Your treadmill has a pair of transport wheels built

into the frame. To move, make sure the treadmill is

folded and securely latched. Then firmly grasp the

 

 

CONDITIONING

handlebars, tilt the treadmill back and roll.

 

&

 

 

MAINTENANCE

 

Our Treadmills are heavy, use care and additional help if necessary when moving.

 

Do not attempt to move or transport treadmill unless it is in the upright, folded

TROUBLESHOOTING

WARNING

position with the lock latch secured. Failure to follow these instructions could

 

 

 

 

result in injury.

LIMITED

 

 

WARRANTY

14

 

 

 

TENSIONING­THE RUNNING BELT

The running belt has been properly adjusted at the factory before it was shipped. At times the belt can move off-center during shipment.

CAUTION: Running belt should NOT be moving during tensioning. Over-tightening the running belt can cause excessive wear on the treadmill as well as its components. Never over-tighten the belt.

If you can feel a slipping sensation when running on the treadmill, the running belt must be tightened. In most cases, the belt has stretched from use, causing the belt to slip. This is a normal and common adjustment. To eliminate this slipping, turn the treadmill off and tension both the rear roller bolts using the supplied Allen wrench, turning them 1/4 TURN to the right as shown. Turn the treadmill on and check for slipping. Repeat if necessary, but NEVER TURN the roller bolts more than 1/4 turn at a time. Belt is properly tensioned when the slipping sensation is gone.

Belt is too far to the right side

Belt is too far to the left side

CENTERING THE RUNNING BELT

The running belt has been properly adjusted at the factory before it was shipped. At times the belt can move off-center during shipment. Before operating the treadmill, make sure the belt is centered and remains centered to maintain smooth operation.

CAUTION: Do not run belt faster than 1/2 mph while centering. Keep fingers, hair and clothing away from belt at all times.

If the running belt is too far to the right side:

With the treadmill running at 1/2 mph, turn the right adjustment bolt clockwise 1/4 turn at a time (using the supplied Allen wrench). Check the belt alignment. Allow belt to run a full cycle to gauge if more adjustment is needed. Repeat if necessary, until the belt remains centered during use.

If the running belt is too far to the left side:

With the treadmill running at 1/2 mph, turn the right adjustment bolt counter-clockwise 1/4 turn at a time (using the supplied Allen wrench). Check the belt alignment. Allow belt to run a full cycle to gauge if more adjustment is needed. Repeat if necessary, until the belt remains centered during use.

15

IMPORTANT PRECAUTIONS INTRODUCTION

ASSEMBLY

BEFORE YOU BEGIN

TREADMILL OPERATION

LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES

T500_Treadmill_Rev.1.7.indd 14-15

4/23/07 10:08:22 AM

Page 8
Image 8
Horizon Fitness T500 manual Proper Usage, Folding, Moving

T500 specifications

The Horizon Fitness T500 is a well-rounded treadmill designed to cater to both beginners and seasoned runners. This treadmill is known for its robust construction, user-friendly features, and innovative technology, making it a suitable addition to any home gym.

One of the standout features of the T500 is its powerful motor. The treadmill is equipped with a 2.5 CHP (Continuous Horsepower) motor that delivers a smooth and consistent performance, allowing users to run at speeds up to 10 miles per hour. This motor is also built for longevity, ensuring that it can handle regular use without losing efficiency.

The T500 boasts a spacious running surface, measuring 20 inches by 55 inches. This generous size provides ample room for users to run or walk comfortably, reducing the risk of accidents during workouts. The treadmill's deck is cushioned, offering a comfortable running experience that minimizes impact on joints, which is particularly beneficial for those who engage in regular cardiovascular exercise.

In terms of technology, the Horizon Fitness T500 is equipped with Bluetooth connectivity, allowing users to sync their devices to the treadmill. This feature enables users to track their workouts through various fitness apps, making it easier to monitor progress and stay motivated. Additionally, the T500 includes integrated speakers and a tablet holder, providing users with entertainment options while exercising.

Another noteworthy characteristic is the T500's adjustable incline feature. Users can customize their workouts with a maximum incline of 10 percent, allowing for varied training intensities and targeting different muscle groups. This feature is particularly appealing for those looking to simulate hill running or increase the caloric burn during their sessions.

The console of the T500 is intuitive and easy to navigate, featuring quick-access buttons for speed and incline adjustments, as well as pre-set workout programs that cater to different fitness levels and goals. The large display provides essential workout statistics, including time, distance, speed, calories burned, and heart rate, ensuring users have all the information they need at their fingertips.

In conclusion, the Horizon Fitness T500 treadmill combines powerful performance, user-friendly technology, and adaptable features, making it a fantastic choice for anyone looking to enhance their fitness routine at home. Whether you're walking, jogging, or sprinting, the T500 is designed to meet diverse workout needs while providing comfort and durability.