8)Move the control switch to the "OFF" position. Remove the upper front, top and left side panels.
9)Move the power switch to the "OFF" postion. Unplug the icemaker from the electrical outlet.
10)Disconnect the ice transport hose from the spout, and pour fresh water into the ice transport hose to rinse out the solution and fill the evaporator and reservoir. Be careful not to overfill the reservoir. Reconnect the transport hose.
11)Plug the icemaker back in. Move the power switch to the "ON" position and replace the panels in their correct positions.
12)Move the control switch to the "ICE" position. Run the icemaker until it stops automatically.
13)Move the control switch to the "DRAIN" position, and wait about 15 minutes for the water system to drain.
14)After the water has drained, move the control switch to the "OFF" position. Remove the upper front, top and left side panels.
15)Move the power switch to the "OFF" position. Unplug the icemaker from the electrical outlet.
16)Open the water supply line shut-off valve. Check for water leaks.
17)Plug the icemaker back in. Move the power switch to the "ON" position and replace the panels in their correct positions.
18)Move the control switch to the "ICE" position and run the icemaker about 30 minutes.
19)Move the control switch to the "OFF" position.
20)Activate the dispense sensor to remove the ice from the storage bin. Remove the upper front, top and left side panels.
21)Move the power switch to the "OFF" position. Unplug the icemaker from the electrical outlet.
22)Remove the front cover of the storage bin. Pour warm water into the storage bin to melt any remaining ice.
23)Clean the storage bin with water.
WARNING
Do not use ice produced from the cleaning and sanitizing solution. Be sure no ice remains in the storage bin.
24)Replace the front cover of the storage bin, then plug the icemaker back in. Move the power switch to the "ON" position and replace the panels in their correct positions.
25)Move the control switch to the "DRAIN" position, and wait about 15 minutes for the water system to drain.
Note: If cleaning the dispensing components, proceed to "B. Cleaning and Sanitizing Instructions - Dispensing Components."
26)After the water has drained, move the control switch to the "ICE" position to start the automatic icemaking process.
16
