D. Preparing the Icemaker for Long Storage
WARNING
When the icemaker is not used for two or three days under normal conditions, it is sufficient to only move the control switch to the "OFF" position.
When storing the icemaker for extended time or in
remove the ice from the bin. The bin should be cleaned and dried. Drain the icemaker water hoses using air or carbon dioxide to prevent damage at
1)Close the water supply line
2)Move the control switch to the "OFF" position. See Fig. 5.
3)Move the dispense mode switch to the "CONTINUOUS" position. See Fig. 5.
4)Activate the dispense sensor to remove the ice from the storage bin.
5)Move the control switch to the "ICE" position.
6)Allow the icemaker to make ice until it stops automatically.
7)Move the control swtich to the "OFF" position.
8)Remove the upper front, top and left side panels.
9)Move the power switch to the "OFF" position. See Fig. 4.
10)Unplug the icemaker from the electrical outlet.
11)Remove the front cover of the storage bin. Pour warm water into the storage bin, to melt any remaining ice. Dry out the storage bin.
12)Disconnect the transport hose. Remove any ice remaining in the hose.
13)Replace the storage bin cover and transport hose in their correct positions.
14)Plug the icemaker back in.
15)Move the power switch to the "ON" position. Replace the panels in their correct positions.
16)Move the control switch to the "DRAIN" position and wait for about 15 minutes for the water system to drain.
17)After the water has drained, move the control switch to the "ICE" position.
18)Open the potable water supply line drain valve and blow the line out using compressed air or carbon dioxide.
19)Close the potable water supply line drain valve.
20)Move the control switch to the "OFF" position. Remove the front panel.
21)Move the power switch to the "OFF" position.
22)Unplug the icemaker.
23)Replace the front panel in its correct position.
IMPORTANT
Before operating the icemaker again, check that the water supply line drain valve is closed, and open the water supply line
20
