G. Final Checklist
1)Is the icemaker level?
2)Is the icemaker in a site where the ambient temperature is within +45°F to +100°F (+7°C to +38°C) and the water temperature within +45°F to +90°F (+7°C to +32°C) all year around?
3)Is there at least 24" (61 cm) clearance at top for maintenance or service?
4)Have the shipping carton and all tape and packing been removed from the icemaker?
5)Are all components, fasteners, and thumbscrews securely in place?
6)Have all electrical and piping connections been made?
7)Has the power supply voltage been checked or tested against the nameplate rating? And has a proper ground been installed to the icemaker?
8)Are the water supply line
Note: The icemaker may stop running when the water supply is OFF, or if the pressure is below 10 PSIG. When the proper water pressure is reached, the icemaker will automatically start running again.
9)Are the compressor
10)Has the bin control switch been checked for correct operation? Move the actuator located on the inside of the bin top panel. The compressor should stop within 90 seconds, and the gear motor within 150 seconds.
11)Has the end user been given the instruction manual, and instructed on how to operate the icemaker and the importance of the recommended periodic maintenance?
12)Has the end user been given the name and telephone number of an authorized service agent?
13)Has the warranty tag been filled out and forwarded to the factory for warranty registration?
14)Have the safety switch brackets moved out of location during shipping? Make sure they are in position as illustrated in Fig. 3.
15)Has the safety switch been checked for correct operation? Activate the safety switch. The ice machine should shut down immediately. Turn the ice machine off, then back on, to reset.
Spout
Safety Bracket (A)
Safety Switch | Safety Bracket (B) |
Fig. 3
