16)Move the Control Switch to the “ICE” position.
17)Close the Cleaning Valve.
18)Replace the Front Panel in its correct position.
19)Turn on the power supply to fill the Water Tank with water.
20)Turn off the power supply after 3 minutes.
21)Remove the Front Panel, and fully open the Cleaning Valve.
22)Move the Control Switch to the “WASH” position.
23)Replace the Front Panel in its correct position.
24)Turn on the power supply to rinse off the cleaning solution.
25)Turn off the power supply after 5 minutes.
26)Remove the Front Panel.
27)Remove the Insulation Panel by removing thumbscrew, lifting up the panel slightly and pulling it toward you. Remove Cube Guide B by removing thumbscrew. Remove Cube Guide A. Remove Overflow Cap, Overflow Pipe, and Water Shield.
28)Remove the Drain Plug located inside the Water Tank. Drain the Water Tank. Replace the Drain Plug in its correct position.
29)Replace Water Shield, Overflow Pipe, Overflow Cap, Cube Guide A, Cube Guide B, and Insulation Panel in their correct positions.
30)Repeat the above steps 16) through 29) three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 10) in “[b] SANITIZING PROCEDURE.”
32
