Installation
Choose where you want to install your dishwasher, you can place it so that its sides or back panel are side by side with furniture or up against the wall. The dishwasher is providedwithwatersupplyanddrain hoses, which can be directed towards the left or right to facilitate appropriateinstallation.
Levelling.
Once the appliance is positioned, adjust the feet by screwing them in or out depending on how high you want it and to level it so that it is horizontal. Make sure that it is not inclined more than 2 degrees. If the applianceislevel,itwill helpensure its correct operation.
Cold water connection. Connect the cold water supply hose, inserting the small filter supplied with the dishwasher and making sure that it is fastened tightly in place (see figure 2). If the water hoses are new or have been outofuseforanextendedperiodof
Connect to the Water Supply...
-For your dishwasher to operate correctlyitrequireswaterpressures in the range of
-Ensurethatthenewhosesupplied is connected and the old hose is disposed of safely.
-Ensure the fill hose is only fitted to the cold water supply. DO NOT overtighten the hose connector, hand tight is sufficient.
-Ensure the fill hose is not kinked.
-Tap connections (if applicable): A range of adaptors are available to suit your tap.
-DO NOT connect the dishwasher toasingleoutletinstantaneouswater heater or an electric heater.
Drain hose connection. WARNING: Connect your dishwasher drain hose to pipes which connect to the foul drain system and not to surface water drains.
Standpipe:
Ensure that the hose is not pushed too far down the standpipe.
If the end of your drain hose is fitted with‘retainingflaps’,ensuretheyare insertedfullyintothestandpipe. This will prevent the pipe from jumping out during installation and use.
DO NOT position the standpipe near an electrical outlet. ENSURE that the drain hose is not kinked and it is routed as shown in thediagram.
The standpipe should have a bore of at least 38mm (11/2”). It should be installed as shown, have a trap fitted and must discharge into the same drain system as your household sink.
SinkWasteSystem: For under sink drainage:
Before connecting the drain hose, remove any internal restrictions - This will prevent a build up of debris which could cause a blockage.
Remove any restrictions from the waste spigot and ensure that the sealingbungisremoved.Thehose should be routed, such that it is raised to a minimum height of 800mm(31/2”).
NOTE: Ensure the sink outlet pipe has a minimum diamtere of 32mm.
time, let the water run to make sure it is clear and free of impurities beforemakingtheconnection.Ifthis precaution is not taken, the water inlet could get blocked, causing damage to your dishwasher.
A
Fig.2
IMPORTANT: For the correct operation of your dishwasher, it is essential to comply with the following information:
It MUST NOT be connected to a surface water drain.
1.Untie the end of the GREY drainage hose from the rear of the appliance.
2.Reposition the ‘Hooked End Support’ as required along the GREY drainage hose.
3.If fitting an under sink waste disposal unit, cut out the membrane, bung or blanking plug.
4.Attach the GREY drainage hose to the under sink waste disposal unit securely, using the clip and rubber tube supplied.
Ensure the drain hose is securely attached, to prevent it coming away while the machine is in use and causing a flood.
Remember you will be charges for a service call is a problem with your appliance is caused by incorrect installation or misuse.
6
