Emerson 2700, 1700 installation manual Power down the transmitter

Installing the Transmitter

WARNING

Using a dry cloth to clean the display cover can cause static discharge, which could result in an explosion in an explosive atmosphere.

To reduce the risk of an explosion, always use a damp cloth to clean the display cover in an explosive atmosphere.

To rotate the display, follow the instructions below:

1.Power down the transmitter.

2.Remove the end-cap clamp by removing the cap screw. See Figure 2-10.

3.Turn the display cover counterclockwise to remove it from the main enclosure.

4.Carefully loosen (and remove if necessary) the semicaptive display screws while holding the display module in place.

5.Carefully pull the display module out of the main enclosure until the sub-bezel pin terminals are disengaged from the display module.

Note: The display pins may come out of the board stack with the display module. If this happens, simply remove the pins and reinstall them.

6.Rotate the display module to the desired position.

7.Insert the sub-bezel pin terminals into the display module pin holes to secure the display in its new position.

8.If you have removed the display screws, line them up with the matching holes on the sub-bezel, then reinsert and tighten them.

9.Place the display cover onto the main enclosure. Turn the display cover clockwise until it is snug.

10.Replace the end-cap clamp by reinserting and tightening the cap screw.

11.Restore power to the transmitter.

Before You Begin

Installing the Transmitter

Sensor Wiring

Output Wiring – Analog

Installation Manual 17