ding. To avoid this happening, you should place a heat-resistant plastic spoon or a glass rod in the container before starting to heat liquids. Anyway, care shall be taken when handling the container.

16) Do not heat spirit with a high alcohol content, nor large quantities of oil, as these could catch fire !

17) The contents of feeding bottles and baby food jars shall be stirred or shaken and the temperature shall be checked before consumption in order to avoid burns. It is also advisable to stir or shake the food in order to ensure that it has an even temperatu- re. When using commercially available bottle sterilisers, before turning the oven on, ALWAYS make sure the container is filled with the quantity of water indicated by the manufacturer.

N.B. When the oven is used for the first time it is possible that, for a period of approx. 10 minutes, it may produce a “new” smell and a small amount of smoke. This is only a result of protective substances applied to the heating element.

1.5 TECHNICAL DATA

Outer measurements

(see building-in)

Inner measurements (LxDxH)

322x202x330

Oven’s net volume

24 Lt

Approximate weight

20 Kg

Turntable diameter

27,5 cm

Oven light

25 w

OUTPUT POWER - MICROWAVE: 900 W (IEC705)

For additional data, consult the data plate placed on the front side of the appliance.

This appliance complies to E.E.C. directive no. 89/336 and 92/31 regarding Electromagnetic Compatibility, and to directive 89/109/E.E.C. regarding materials which come into contact with food.

1.6INSTALLATION AND ELECTRICAL CONNECTION

The oven must be built-in at a minimum hight of 850 mm.

1) Remove all the accessories and wash them.

2) Clean the inside with a soft, damp cloth.

3) Check that there is no damage as a result of transportation, and in particular that the door opens and clos- es properly.

4) Place the support (H) in the centre of the circular groove and fix the turntable (G) to it. The spindle (D) should be inserted in the corresponding groove in the centre of the turntable.

5) After the installation has been performed, the power supply cable and the power socket must be easy to access.

6) Only a qualified electrician may install or relocate a socket outlet.

7) Only connect the appliance to a power socket with a power capacity of at least 16A. Also make sure that the main switch installed in your home has a minimum power capacity of 16A in order to avoid it suddenly trip- ping while the oven is on.

8) Before use, check that the power supply voltage is the same as the one shown on the rating label and that the power outlet is properly earthed: the manufacturer disclaims any liability in the event of non-compliance with this safety regulation.

10

Page 10
Image 10
Hotpoint MWH221 manual Technical Data, Installation and Electrical Connection, Outer measurements