CHAPTER 2 – USING THE CONTROLS AND MODES
2.1 HOW TO ADJUST THE CLOCK
•When this appliance is first plugged in, or after there has been a power failure, the figure 12:00 will start blink- ing on the display.
To set the time of day, proceed as follows:
1Push the button 
(8).
(An hour will begin blinking on the display.)
12
2Set the correct hour by turning
the 
(7). (The hour will begin blinking on the display.)
14
3 Push the button 
(8) once again. (The hour will disappear from the display and the minutes will begin to blink).
00
4Set the number of minutes you
want by turning the knob 
(7) (The minutes set will begin blink- ing on the display.)
35
5Push the button 
(8) one more time. (The time set will appear on the display.)
14:35
•If you wish to change the time on the control panel once it has been set, push the button 
(8) and then proceed to a setting of the time as indicated above.
•You can obtain a showing of the time of day even after the oven has started operating simply by pushing the
button 
(8). (The time will be shown for 3 seconds.)
14
