Hotpoint SX 896 PX S Sliding rack kit assembly, Cleaning the oven door, Inspecting the seals

• The inside of the oven should ideally be cleaned after GB each use, while it is still lukewarm. Use hot water and detergent, then rinse well and dry with a soft cloth. Do

not use abrasive products.

• All accessories - with the exception of the sliding racks

- can be washed like everyday crockery, and are even

!Do not touch the light bulb directly with your hands.

!Do not use the oven lamp as/for ambient lighting.

Sliding rack kit assembly

dishwasher safe.

• We recommend that detergents are not sprayed directly

onto the control panel, but that a sponge is used instead.

!Never use steam cleaners or pressure cleaners on the appliance.

Cleaning the oven door

! The door of LED INSIDE models cannot be removed.

Clean the glass part of the oven door using a sponge and

a non-abrasive cleaning product, then dry thoroughly with

A

To assemble the sliding racks:

1.Remove the two frames, lifting them away from the spacers A (see figure).

a soft cloth. Do not use rough abrasive material or sharp

metal scrapers as these could scratch the surface and cause

the glass to crack.

For more thorough cleaning purposes, the oven door may

be removed:

1. Open the oven door fully (see diagram).

2. Use a screwdriver to lift up and turn the small levers F

located on the two hinges (see diagram).

Left	Right guide
guide rail	rail
B
	C
	of
		Direction
		extraction

2.Choose which shelf to use with the sliding rack. Paying attention to the direction in which the sliding rack is to be extracted, position joint B and then joint C on the frame.

3. Grip the door on the two outer sides and close it approximately half way. Pull the door towards you, lifting it out of its slot (see diagram). To replace the door, reverse this

D

3.Secure the two frames with the guide rails using the holes provided on the oven walls (see diagram). The holes for the left frame are situated at the top, while the holes for the right frame are at the bottom.

4.Finally, fit the frames on the spacers A.

sequence.

!Do not place the sliding racks in position 5.

Inspecting the seals

Check the door seals around the oven regularly. If the seals are damaged, please contact your nearest Service Centre (see Assistance). We recommend that the oven is not used until the seals have been replaced.

Replacing the light bulb

Automatic cleaning with the FAST CLEAN function

With the FAST CLEAN mode, the internal temperature of the oven reaches 500°C. The pyrolytic cycle is activated, burning away food and grime residues. Dirt is literally incinerated.

Keep children away from the appliance during the automatic cleaning cycle as surfaces may become very hot. Particles may ignite inside the oven as a result of the combustion process. There is no cause for concern: this process is both normal and hazard-free.

Lamp

Holder

compartment

Lamp

Glass cover

To replace the oven light bulb:

1.Remove the glass cover of the lamp-holder.

2.Remove the light bulb and replace it with a similar one: halogen lamp voltage 230 V, wattage 25 W, cap G 9.

3.Replace the glass cover (see diagram).

Before initiating the FAST CLEAN mode:

•clean the oven door;

•remove large or coarse food residues from the inside of the oven using a damp sponge. Do not use detergents;

•remove all accessories and the sliding rack kit (where present);

•do not place tea towels or pot holders over the oven handle.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

12