HP Installing the Intel EtherExpress Pro 100B-TX PCI Ethernet Adapter, Requirements, Procedure

9 Installing the Intel EtherExpress Pro 100B-TX PCI Ethernet Adapter

Microsoft Windows NT 3.51 Workstation

9Installing the Intel EtherExpress Pro 100B-TX PCI Ethernet Adapter

Microsoft Windows NT 3.51 Workstation

Connecting to a Windows NT 3.51 Server

Requirements

•HP Vectra with Windows NT 3.51 Workstation.

•Intel EtherExpress Pro 100B-TX PCI Ethernet card and drivers disk.

•Microsoft Windows NT3.51 Workstation media.

•Microsoft Windows NT 3.51 Server system that supports NetBEUI, TCP/ IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.

Device Configuration

Device Configuration	Vectra Vli8	Vectra VEi7	Vectra VEi8
Interrupt	09	03	10
I/O Address	1020	DCE0	E400

Procedure

1With the HP Vectra turned off, install the Intel EtherExpress Pro 100B- TX PCI Ethernet adapter into a PCI slot.

2Connect network cable media to the Intel EtherExpress Pro 100B-TX PCI Ethernet card.

3Power on the machine and start the machine in MS-DOS mode.

4Insert the Intel driver disk and execute “SETUP.EXE”.

5Select “View Adapter Settings” and verify the resource settings listed above under the heading “Device Configuration”.

6If changes are required, save those changes and exit.

7Remove the Intel Software driver diskette and restart the system.

8After Windows loads, go to the “MAIN” program group, and double-click on “Control Panel”.