Using the ProCurve Web Browser Interface
Web Configuration
SNMP Configuration
This page allows you to configure the Simple Network Management Protocol (SNMP). The SNMP agent permits READ ONLY access to the switch. Any system in the network using management software can be used to discover the switch. You can set the following options:
Field Attributes
•SNMP Enabled – Enables or disables SNMP. (Default: Enabled)
•Read Community – Community string for read access to the SNMP protocol.
Web – Click SNMP, Configuration.
Browser Interface
Using the ProCurve Web
Ping Test
This operation allows you to test the network connections by sending an Internet Control Message Protocol (ICMP) echo request packet from the switch to other devices on the network. The page will display the results of the operation.
Field Attributes
Ping Parameters
•Target IP Address – The IP address of the device to ping on the network.
•Count – Number of packets to send. (Default: 1)
•Time Out (in secs) – Number of seconds to wait for a response. (Default: 1)