Optical drive

NOTE: This section applies only to computer models equipped with an Intel processor.

Description

Spare part number

 

 

DVD±RW Double Layer SuperMulti Drive

720671-001

 

 

Before removing the optical drive, follow these steps:

1.Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect the power from the computer by unplugging the power cord from the computer.

3.Disconnect all external devices from the computer.

4.Remove the battery (see Battery on page 47).

Remove the optical drive:

1.Loosen the Phillips PM3.0×10.5 captive screw (1) that secures the service cover to the computer.

2.Slide the service cover (2) forward until it disengages from the computer.

3.Remove the service cover (3).

The service cover is available using spare part number 720675-001.

4.Position the computer with the left side toward you.

5.Remove the Phillips PM2.5×7.0 screw (1) that secures the optical drive to the computer.

6.Insert a flat-bladed screwdriver or similar tool into the optical drive tab access (2) and press the tab to the left to release the optical drive from the computer.

48 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts