Canon IR2200, IR3300, IR2800 manual E500, Finisher-J1 Error Codes

CHAPTER 6 SELF DIAGNOSIS

1.4 Finisher-J1 Error Codes

When the finisher’s self diagnostic mechanism has gone ON, it may be reset by turning off and then on its host machine.

While the finisher is out of order, prints can still be made by disabling the finisher opera- tion as follows (other than delivery):

1)Service mode

[1]Turn off and then on the main power switch.

[2]Set '1' to SORTER>OPTION>MD-SPRTN.

[3]Turn off and then on the main power switch.

2)User mode

[1]Turn off and then on the main power switch.

[2]Set 'OFF' the following: 'adjustment/cleaning'>'staple/offset function'.

[3]Turn off and then on the main power switch.

E500

0000	The communication between the copier and the finisher is disrupted and is
	not corrected for 5 sec or less.
Cause	The copier harness is faulty. (disconnected connector, open circuit) The fin-
	isher controller PCB or the copier’s DC controller PCB is faulty.

E514

0000	At the start of the motor CW operation, the stack handling motor (M2) may
	be driven for a specific number of rotations; however, the stack delivery le-
	ver home position sensor (S8) does not go ON.
Cause	The stack handling motor (M2) is faulty. The stack delivery lever home po-
	sition sensor (S8) is faulty, the connector is disconnected, or an open circuit
	exits. The stack handling motor (M2) relay harness is faulty. The return
	roller is faulty.

E530

0000	The alignment motor (M4) is driven for a specific number of rotations, but
	the aligning plate home position sensor (S7) does not go ON.
	The alignment motor (M4) is driven for a specific number of rotations, but
	the aligning plate home position sensor (S7) does not go OFF.
Cause	The rear alignment motor (M4) is faulty. The rear aligning plate home posi-
	tion sensor (S7) is faulty. The rear alignment motor relay harness is faulty.
	The rear aligning plate is subjected to an excess load.

COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001 6-43 T