Canon IR2200, IR3300, IR2800 manual Config, Sharp, Cotdpc-D, Df-Bline, Fix-Smr

CHAPTER 5 SERVICE MODE

COPIER>OPTION>BODY

CONFIG
	Use it to select any of the multiple pieces of firmware stored on the hard
	disk to suit the selected destination and paper size:
Settings	XXYYZZAA
	XX: country (JP), YY: language (ja), ZZ (00): destination, AA (00): paper
	configuration
	The method of indication COPIER>DISPLAY>USER>LANGUAGE.
	The selections in parentheses are default selections; for the country and the
	languages, names are given.
	Using the Mode
	1)	Select <CONFIG>.
	2)	Select the item to change (to highlight), and press the +/- key.
	3)	Each press on the +/- key move the selection to the next item.
	4)	When the desired item is indicated, press the OK key.
	5)	Turn off and then on the main power switch.
SHARP
	Use it to change the level of sharpness of soft the image.
	• A higher setting makes the image sharper.
Settings	1 to 5 (default: 3)
COTDPC-D
	for factory.
Settings	0 to 3 (default: 0)
DF-BLINE
	Use it to enable or disable black line reduction mode (disabling edge em-
	phasis) for stream reading.
Caution	When enabled, the black lines will be less conspicuous but the edges of the
	images will be less crisp.
Settings	0: disable (default)
	1: enable
FIX-SMR
	Use it to set the fixing trail removal mode in a high humidity environment.
Caution	When ‘1’ is set, the following will occur:

•The laser intensity will be reduced by 50 V.

•The fixing film control speed is changed from 539 to 535 m/sec.

•The fixing/feeding speed is reduced:

B4:	from 14	→	10 ppm
B5R:	from 28	→	15 ppm
LGL:	from 14	→	10 ppm
A4R,etc.: from 18		→	10 ppm

Settings	0:	disable (default)
	1:	enable

COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001 5-85 T