Canon IR2800, IR3300, IR2200 manual Backing Up Data, Making Preparations

CHAPTER 7 UPGRADING

2.2 Backing Up Data

2.2.1 Making Preparations

•Install the system software to the Service Support Tool, making sure that its version is the same as that of the machine in question.

•Check to make sure that the machine’s Data lamp is OFF.

•Turn off the machine’s main power switch, and disconnect the power plug; as necessary, disconnect the network cable.

2.2.2 Making Connections

The discussions that follow assume the use of a parallel cable:

1)Using a parallel cable, connect the PC to the parallel connector on the right side of the controller.

•At this time, the PC must remain OFF.

•Connect the 25-point connector of the parallel cable to the PC and the 36-pin connector

to the machine.

2)Turn on the power switch of the PC, and start up the Service Support Tool.

3)Connect the machine’s power plug to the power outlet, and turn on its main power switch.

4)Start service mode.

5)Make the following selections so that the machine will enter download standby mode (notation “STNDBY”): COPIER>FUNCTION>SYSTEM>DOWNLOAD.

You can select ‘network’ as the interface for data backup. Here, the use of a bi-Centronics cable is assumed.

Memo

COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001 7-35 T