Canon IR2200 Adjusting the Height of the Side Member, Before Making Adjustments, F03-509-01 22 T

CHAPTER 3 STANDARDS AND ADJUSTMENTS

5.9 Adjusting the Height of the Side Member

5.9.1 Before Making Adjustments

1)Disconnect the machine from its host machine, and then connect it once gain, thereby finding out whether the impact of connection causes the host machine to slide over or the machine to wobble. If any such problem is noted, adjust the height of the side member as follows; otherwise, these steps need not be per- formed:

5.9.2 Making Adjustments

1)Connect the machine to the host ma- chine.

2)Take out the paper from the deck.

3)Remove the right cover of the machine.

4)Loosen the two fixing screws [2] of the side member [1].

5)With the side member in contact with the floor, tighten the fixing screws. At this time, refer to the index so that the left and right screws match against the same index.

6)Disconnect the machine from the host machine, and then connect it once again. If it can be done without extra force, mount the right cover for the ma- chine, and put the paper back into the deck. If extra force is needed, go to the next step.

7)Check the index of the side member.

8)Loosen the fixing screws of the side member.

9)While referring to the index, raise the side member 1 mm, and then tighten the fixing screws.

10)Mount the right cover, and then put the paper back into the deck.

[2]

[1]

F03-509-01

3-22 T COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001