Canon IR2800, IR3300, IR2200 manual Scanslct, Trans-Sw, Priac-Sw, Sens-Cnf, 84 T

CHAPTER 5 SERVICE MODE

COPIER>OPTION>BODY

SCANSLCT
	Use it to enable or disable the original size detection mechanism for the
	ADF.
	• When enabled, the scan size is determined in relation to the original
	size.
Settings	0: off (default), 1: on
TRANS-SW
	Use it to set the transfer charging bias output control method for large-size
	paper.
Settings	0: normal (auto mode), 1: constant voltage control (manual mode)
Caution	When manual mode is selected, make fine settings in ADJUST>HV-
	TR>TR-N1.
PRIAC-SW
	If an image fault occurs as a result of faulty charging of the drum unit,
	change the level of primary charging current to correct the fault. It is effec-
	tive if a sandy image (white dots in solid areas) occurs between the installa-
	tion of the drum unit to printing of 2000 sheets.
Settings	0: no increase in charging current (default), 1: increase in charging
	current
Caution	The setting of this mode is cleared (1 → 0) for the following:
	• When APVC is executed after installing a new drum unit.
	• When COPIER>FUNCTION>D-GAMMA is executed in service mode.
	• When the setting is changed in this service mode.
SENS-CNF
	Use it to set the arrangement of the original sensors.
Settings	0: AB-configuration (default, 1: Inch-configuration, 2: A-configuration)
Caution	If you have changed the arrangement of the original sensors, select the ap-
	propriate setting to suit the new arrangement.

5-84 T COPYRIGHT © 2001 CANON INC. CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001